Command Line Reference Guide

572 | Interfaces
www.dell.com | support.dell.com
Command
History
Usage
Information
When an E300 system boots up and a single SFM is active this configuration, any ports configured
with this feature will be shut down. If an SFM fails (or is removed) in an E300 system with two SFM,
ports configured with this feature will be shut down. All other ports are treated normally.
When a second SFM is installed or replaced, all ports are booted up and treated as normally. This
feature does not take affect until a single SFM is active in the E300 system.
duplex (Management)
c e
Set the mode of the Management interface.
Syntax
duplex {half | full}
To return to the default setting, enter no duplex.
Parameters
Defaults
Not configured
Command Modes
INTERFACE
Command
History
Usage
Information
This command applies only to the Management interface on the RPMs.
Related
Commands
duplex (10/100 Interfaces)
c e s
Configure duplex mode on any physical interfaces where the speed is set to 10/100.Syntax
duplex {half | full}
To return to the default setting, enter no duplex.
Version 7.7.1.0 Introduced on E300 systems only
half Enter the keyword half to set the Management interface to transmit only in one direction.
full Enter the keyword full to set the Management interface to transmit in both directions.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
Version 6.4.1.0 Documentation modified—added Management to distinguish from duplex (10/100
Interfaces)
interface ManagementEthernet
Configure the Management port on the system (either the Primary
or Standby RPM).
duplex (Management)
Set the mode of the Management interface.
management route Configure a static route that points to the Management interface or a
forwarding router.
speed (Management interface)
Set the speed on the Management interface.