Command Line Reference Guide

524 | Dell Networking OS Service Agent
www.dell.com | support.dell.com
Parameters
Defaults
None
Command Mode
CALL-HOME TEST-LIST
Command
History
Usage
Information
Dell Networking OS does not allow you to configure a test that makes no sense, such as cpu-5-min
greater-than number 150. CPU percentage utilization can only go up to 100, so 150 is not
possible. Dell Networking OS displays the acceptable range, as shown below
Examples
This example shows a couple other keyword configuration examples.
Related
Commands
test-condition statistic Enter the keyword test-condition, followed by one of the following
statistic request types:
cpu-1-min: Average CPU utilization for 1 minute
cpu-5-min: Average CPU utilization for 5 minutes
interface-bit-rate {input | output} slot#: Instantaneous bit rate
on a given line card
interface-crc interface: Number of CRC errors on a given interface
interface-rate interface: Packet rate on a given interface
interface-throttles interface: Number of throttles on an interface
memory-free: Free system memory
memory-free-percent: Free system memory free in percentage
memory-used: System memory used
memory-used-percent: System memory used in percentage
wred-drops interface: Number of WRED drops on an interface
(E-Series only)
operator Enter one of the following Boolean comparison operators: decrease,
equal-to, greater-than, increase, less-than, not-equal-to,
no-change.
number value Enter the keyword number, followed by an integer to be the comparison
value to the designated statistic, in the range pertinent to the statistic.
cpu | rpm-any
Enter the processor that will be tested: cp, lp, rp1, rp2, or test all RPM CPUs
with the keyword
rpm-any.
Version 8.2.1.0
Removed
message-text keyword. Added operators.
Version 7.8.1.0 Introduced on C-Series and E-Series
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than ?
number The boolean comparison value
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than number ?
<0-100> Enter the boolean comparison value
FTOS(conf-callhome-testlist-test)#test-condition cpu-5-min greater-than number 10
FTOS(conf-call-home-testlist-test)# test-condition interface-rate input 1 less-than
number 98
FTOS(conf-call-home-testlist-test)# test-condition memory-used not-equal-to number
1000
dampen Set a delay before sampling for a test condition again after it has been matched.
test-limit Set the number of times that the test list that should be executed.