Command Line Reference Guide

File Management | 43
Example
Related
Commands
Usage
Information
The show boot verification output displays Failed in the following cases:
• the checksum of the file in bootflash is wrong.
• the file is non-existent.
Use the show boot system all command to identify the reason. In both the cases, a new file should
be placed in bootflash.
show bootvar
c e
Display the variable settings for the E-Series boot parameters.
Syntax
show bootvar
Command Modes
EXEC Privilege
Command
History
Example
Command Output example: show bootvar
FTOS#show boot verification all
System image verification in progress...
System image verification:
===========================
Type A B
-------------------------------------
% Error: Linecard 0 is not present.
Linecard 1 Passed Failed
Linecard 2 Passed Failed
% Error: Linecard 3 is not present.
Linecard 4 Passed Failed
% Error: Linecard 5 is not present.
Linecard 6 Passed Failed
Linecard 7 Passed Failed
RPM 1 Passed Passed
show boot system
Displays information about boot images currently configured on the
system.
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
FTOS#show bootvar
PRIMARY IMAGE FILE = ftp://box:password@10.31.1.205//home/5.3.1/5.3.1.0/FTOS-ED-RPM1-5.3.1.0.bin
SECONDARY IMAGE FILE = variable does not exist
DEFAULT IMAGE FILE = flash://FTOS-ED-5.3.1.0.bin
LOCAL CONFIG FILE = variable does not exist
PRIMARY HOST CONFIG FILE = variable does not exist
SECONDARY HOST CONFIG FILE = variable does not exist
PRIMARY NETWORK CONFIG FILE = variable does not exist
SECONDARY NETWORK CONFIG FILE = variable does not exist
CURRENT IMAGE FILE = ftp://box:password@10.31.1.205//home/5.3.1/5.3.1.0/FTOS-ED-RPM1-5.3.1.0.bin
CURRENT CONFIG FILE 1 = flash://startup-config
CURRENT CONFIG FILE 2 = variable does not exist
CONFIG LOAD PREFERENCE = local first
BOOT INTERFACE GATEWAY IP ADDRESS = variable does not exist
FTOS#