Command Line Reference Guide

62 | C-Series Diagnostics and Debugging
www.dell.com | support.dell.com
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
History
Usage
Information
Layer 2 Debug Command
show software macagent
c
This command displays tables and advanced debugging information related to the MAC Agent
process.
Syntax
show software macagent {configs | mac-addr-table {dump | count} | port interface
interface | port-channel number | stg number | vlan number} line-card number
Parameters
interface
Enter one of the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a
number from 0 to 16383.
• For the management interface on the RPM, enter the keyword
ManagementEthernet followed by the slot/port information. The slot
range is 0-1 and the port range is 0.
• For the Null interface, enter the keywords
null 0.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
C-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
number
Enter the linecard slot number.
Range: 0-7 for the C300
Version 4.2.1.0 Introduction
Warning: Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
configs The keyword configs shows the initial configurations of the MAC Agent.
mac-addr-table The keyword mac-addr-table shows the number of MAC addresses in the MAC
Agent software.
dump The keyword dump shows the MAC addresses present in the software.