Command Line Reference Guide

| 9
Example
(igmp-snoop)
Example
(igmp-snoop
interface
port-channel)
Example (NDP
and Non-VLT
ARP)
show vlt detail
c
Displays detailed status information about VLT domains currently configured on the switch.
Syntax
show vlt detail
Defaults
Not Configured.
Command Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Example
FTOS# show vlt counter igmp-snoop
Total IGMP VLT counters
-----------------------
IGMP MRouter Vlans count : 1
IGMP Mcast Groups count : 5
FTOS#show vlt counter igmp-snoop interface port-channel 2
VLT Port-ID: 2 IGMP Counter
-----------------------
IGMP MRouter Vlans count : 0
IGMP Mcast Groups count : 5
FTOS# show vlt counter igmp-snoop interface port-channel 100
VLT Port-ID: 100 IGMP Counter
-----------------------
IGMP MRouter Vlans count : 1
IGMP Mcast Groups count : 0
Ve
FTOS#show vlt counters
Total VLT Counters
-------------------
L2 Total MAC-Address Count: 2
Total Arp Entries Learnt : 0
Total Arp Entries Synced : 0
Total Non-VLT Arp entries Learnt: 0
Total Non-VLT Arp Entries Synced 0
IGMP MRouter Vlans count :
IGMP Mcast Groups count :
Total VLT Ndp Entries Learnt : 2
Total VLT Ndp Entries Synced : 0
Total Non-VLT Ndp Entries Learnt : 0
Total Non-VLT Ndp Entries Synced : 0
Version 8.4.6.0 Introduced on the C-Series.
FTOS# FTOS(conf-if-vl-100)#show vlt detail
Local LAG Id Peer LAG Id Local Status Peer Status Active VLANs
------------ ----------- ------------ ----------- -------------
10 10 UP UP 100, 200, 300, 400,