Command Line Reference Guide

8 |
www.dell.com | support.dell.com
Example
show vlt counters
c
Displays the counter information.
Syntax
show vlt counters [arp| igmp-snoop | interface | mac | ndp]
Parameters
Defaults
Not Configured.
Command Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Usage
Information
If you do not add a parameter such as arp or mac, the output displays all of the counters.
Example
FTOS_VLTpeer1# show vlt backup-link
VLT Backup Link
-----------------
Destination: 10.11.200.18
Peer HeartBeat status: Up
HeartBeat Timer Interval: 1
HeartBeat Timeout: 3
UDP Port: 34998
HeartBeat Messages Sent: 1026
HeartBeat Messages Received: 1025
arp
Enter the keyword arp to display the ARP counter information for the
VLT.
igmp-snoop
Enter the keywords igmp-snoop to display the igmp-snooping counter
information for the VLT.
interface
Enter the keyword interface to display the interface counter
information for the VLT.
mac
Enter the keyword mac to display the MAC address counter information
for the VLT.
ndp
Enter the keyword ndp to display the VLT counter information for NDP.
Version 8.4.6.0 Introduced on the C-Series.
FTOS# show vlt counter
Total VLT counters
-------------------------
L2 Total MAC-Address Count :
IGMP MRouter Vlans count :
IGMP Mcast Groups count :
ARP entries count :