Command Line Reference Guide

2 |
www.dell.com | support.dell.com
Defaults
1 Second
Command Modes
VLT DOMAINS
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
back-up-secondary destination
c
Configure the secondary IPv4 address of the management interface on the remote VLT peer to be used
as the endpoint of the VLT backup link for sending out-of-band hello messages.
Syntax back-up-secondary destination {[ipv4–address] [interval seconds]}
Parameters
Defaults
1 Second
Command Modes
VLT DOMAINS
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
clear vlt statistics
c
Clear the statistics on VLT operations.
Syntax
clear vlt statistics [arp | domain | igmp-snoop | mac | multicast | ndp]
Parameters
Version 8.4.6.0 Introduced on the C-Series.
ipv4–address
Enter the IPv4 address of the secondary backup destination.
interval
seconds
Enter the keyword interval to specify the time interval to send hello
messages. The range is from 1 to 5 seconds. The default is 1 second.
Version 8.4.6.0 Introduced on the C-Series.
domain
Clear the VLT statistics for the domain.
multicast
Display the VLT statistics for multicast.
mac
Clear the VLT statistics for the MAC address.
arp
Clear the VLT statistics for ARP.
igmp-snoop
Clear the VLT statistics for IGMP snooping.
ndp
Clear the VLT statistics for NDP.