Command Line Reference Guide

1430 | Storm Control
www.dell.com | support.dell.com
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
storm-control multicast (Configuration)
c s
Configure the packets per second (pps) of multicast traffic allowed in to the C-Series and S-Series
networks only.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf)
Command
History
Usage
Information
Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter, not against the
multicast storm control meter. It is possible, however, that some multicast control traffic may get
dropped when storm control thresholds are exceeded.
percentage
decimal_value in
E-Series Only: Enter the percentage of broadcast traffic allowed in to the
network. Optionally, you can designate a decimal value percentage, for example,
55.5%.
Percentage: 0 to 100
0 % blocks all related traffic
100% allows all traffic into the interface
Decimal Range: 0.1 to 0.9
wred-profile name E-Series Only: (Optionally) Enter the keyword wred-profile followed by the
profile name to designate a wred-profile.
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of broadcast traffic
allowed into the network.
Range: 0 to 33554431
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 E-Series Only: Added percentage decimal value option
Version 6.5.1.0 Introduced on E-Series
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of multicast traffic
allowed into the network followed by the keyword
in.
Range: 0 to 33554431
Version 7.6.1.0 Introduced on C-Series and S-Series only