Command Line Reference Guide

SNMP and Syslog | 1377
For the remote Engine ID, the host IP and UDP port are the indexes to the command that are matched
to either overwrite or remove the configuration.
Related
Commands
snmp-server group
c e s
Configure a new SNMP group or a table that maps SNMP users to SNMP views.
Syntax
snmp-server group [group_name {1 | 2c | 3 {auth | noauth | priv}}] [read name] [write
name] [notify name] [access-list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]]
To remove a specified group, use the no snmp-server group [group_name {v1 | v2c | v3 {auth |
noauth | priv}}] [read name] [write name] [notify name] [access-list-name | ipv6
access-list-name | access-list-name ipv6 access-list-name]] command.
Parameters
show snmp engineID
Display SNMP engine and all remote engines that are configured on the
router
show running-config snmp Display the SNMP running configuration
group_name
Enter a text string (up to 20 characters long) as the name of the group.
Defaults: The following groups are created for mapping to read/write
community/security-names.
• v1v2creadg — maps to a community/security-name with
ro
permissions
•
1v2cwriteg — maps to a community/security-name rw
permissions
1 | 2c | 3
(OPTIONAL) Enter the security model version number (1, 2c, or 3).
•
1 is the least secure version
•
3 is the most secure of the security modes.
•
2c allows transmission of informs and counter 64, which allows for
integers twice the width of what is normally allowed.
Default: 1
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet
without encryption.
noauth (OPTIONAL) Enter the keyword noauth to specify no authentication of a
packet.
priv (OPTIONAL) Enter the keyword priv to specify both authentication and
then scrambling of the packet.
read name
(OPTIONAL) Enter the keyword read followed by a name (a string of up
to 20 characters long) as the read view name.
Default: GlobalView is set by default and is assumed to be every object
belonging to the Internet (1.3.6.1) OID space.
write name
(OPTIONAL) Enter the keyword write followed by a name (a string of up
to 20 characters long) as the write view name.
notify name
(OPTIONAL) Enter the keyword notify followed by a name (a string of up
to 20 characters long) as the notify view name.
access-list-name
(Optional) Enter the standard IPv4 access list name (a string up to 16
characters long).