Command Line Reference Guide

Security | 1345
Defaults
Not configured.
Command Modes
TRACE LIST
Command
History
Related
Commands
show config
e
View the current IP trace list configuration.
Syntax
show config
Command Modes
TRACE LIST
operator
(OPTIONAL) Enter one of the following logical operands:
•
eq = equal to
•
neq = not equal to
•
gt = greater than
•
lt = less than
•
range = inclusive range of ports (you must specify two ports for the
port parameter.)
port port
(OPTIONAL) Enter the application layer port number. Enter two port
numbers if using the
range logical operand.
Range: 0 to 65535
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination
Enter the IP address of the network or host to which the packets are sent.
precedence precedence Enter the keyword precedence followed by a number from 0 to 7 as
the precedence value.
tos tos-value Enter the keyword tos followed by a number from 0 to 15 as the TOS
value.
count (OPTIONAL) Enter the keyword count to count packets processed by
the filter.
byte (OPTIONAL) Enter the keyword byte to count only bytes processed by
the filter.
log (OPTIONAL) Enter the keyword log to have the information kept in a
Trace-list log file.
Version 7.4.1.0
Deprecated
established keyword—not supported on TeraScale line
cards.
deny
Configure a filter to drop packets.
permit
Configure a filter to forward packets.