Command Line Reference Guide

Router Information Protocol (RIP) | 1261
Command
History
router rip
c e s
Enter the ROUTER RIP mode to configure and enable RIP.
Syntax
router rip
To disable RIP, enter no router rip.
Defaults
Disabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To enable RIP, you must assign a network address using the network command.
Example
Figure 48-1. router rip Command Example
Related
Commands
show config
c e s
Display the changes you made to the RIP configuration. Default values are not shown.
Syntax
show config
Command Modes
ROUTER RIP
Command
History
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
FTOS(conf)#router rip
FTOS(conf-router_rip)#
network Enable RIP.
exit Return to the CONFIGURATION mode.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series