Command Line Reference Guide

1142 | PIM-Source Specific Mode (PIM-SSM)
www.dell.com | support.dell.com
ip pim ssm-range
c e s Specify the SSM group range using an access-list.
Syntax
ip pim ssm-range {access_list_name}
Parameters
Defaults
Default SSM range is 232/8 and ff3x/32
Command Modes
CONFIGURATION
Command
History
Usage
Information
Dell Networking OS supports standard access list for the SSM range. Extended ACL cannot be used
for configuring SSM range. If an Extended ACL is configured and then used in the ip pim
ssm-range {access list name} configuration, an error is reported.
However, if ip pim ssm-range {access list name} is configured first and then the ACL is
configured as an Extended ACL, an error is not reported and the ACL is not applied to the SSM range.
Dell Networking OS recommended best-practices are to configure the standard ACL, and then apply
the ACL to the SSM range. Once the SSM range is applied, the changes are applied internally without
requiring clearing of the TIB.
When ACL rules change, the ACL and PIM modules apply the new rules automatically.
When SSM range is configured, Dell Networking OS supports SSM for configured group range as well
as default SSM range.
When the SSM ACL is removed, PIM SSM is supported for default SSM range only
show ip pim ssm-range
c e s
Display the non-default groups added using the SSM range feature.
Syntax
show ip pim ssm-range
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
access_list_name
Enter the name of the access list.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series.
Version 7.5.1.0 Introduced on E-Series.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on S-Series