Deployment Guide

Control and Monitoring | 99
ip telnet source-interface
c e s
Set an interface’s IP address as the source address in outgoing packets for Telnet sessions.
Syntax
ip telnet source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
Related
Commands
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from zero
(0) to 16383.
• For the SONET interfaces, enter the keyword
sonet followed by slot/port information.
• For a Port Channel, enter the keyword
port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
telnet Telnet to another device.