Deployment Guide

892 | Layer 2
www.dell.com | support.dell.com
mac-address-table static
c e s
Associate specific MAC or hardware addresses to an interface and VLANs.
Syntax
mac-address-table static mac-address output interface vlan vlan-id
To remove a MAC address, use the no mac-address-table static mac-address output interface
vlan vlan-id command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Related
Commands
mac-address
Enter the 48-bit hexidecimal address in nn:nn:nn:nn:nn:nn format.
output interface Enter the keyword output followed by one of the following interfaces:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
vlan vlan-id Enter the keyword vlan followed by a VLAN ID.
Range:1 to 4094.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
show mac-address-table Displays the MAC address table.