Deployment Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 767
Usage
Information
This feature is advertised to BGP neighbors through a capability advertisement. In receiver only mode,
BGP saves the advertised routes of peers that support this capability when they restart.
bgp log-neighbor-changes
c e
Enable logging of BGP neighbor resets.
Syntax
bgp log-neighbor-changes
To disable logging, enter no bgp log-neighbor-changes.
Defaults
Enabled
Command Modes
ROUTER BGP
Command
History
Usage
Information
The bgp log-neighbor-changes command appears in the show config command output.
Related
Commands
bgp non-deterministic-med
c e
Compare MEDs of paths from different Autonomous Systems.
Syntax
bgp non-deterministic-med
To return to the default, enter no bgp non-deterministic-med.
Defaults
Disabled (that is, paths/routes for the same destination but from different ASs will not have their MEDs
compared).
Command Modes
ROUTER BGP
Command
History
Note: Starting in the C-Series release 8.4.7.0, this command is not supported.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
show config View the current configuration
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale