Deployment Guide

74 | BOOT_USER Mode
www.dell.com | support.dell.com
interface management ethernet port
s
Assign a port to be the Management Ethernet interface.
Syntax
interface management ethernet port portID
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
Assign any copper port to be the Management Ethernet interface.
Related
Commands
interface management port config
c e
Configure speed, duplex, and negotiation settings for the management interface.
Syntax
interface management port config {half-duplex | full-duplex | 10m | 100m |
auto-negotiation | no auto-negotiation | show}
Parameters
Defaults
full duplex; auto-negotiation
Command Modes
BOOT_USER
Usage
Information
This command is only available in Boot Flash version 2.0.0.21 and higher.
portID
Enter an S-Series port ID as an integer.
Range: 1 to 48
Version 7.8.1.0 Introduced on S-Series
show interface management ethernet
Display the IP address configured for the Management
interface.
half-duplex Enter the keyword half-duplex to set the Management interface to half-duplex
mode.
full-duplex Enter the keyword full-duplex to set the Management interface to full-duplex
mode.
10m Enter the keyword 10m to set the speed on the Management interface to 10 Mb/
s.
100m Enter the keyword 100m to set the speed of the Management interface to 100
Mb/s.
auto-negotiation Enter the keyword auto-negotiation to enable negotiation on the
Management interface.
no auto-negotiation Enter the keyword no auto-negotiation to disable auto-negotiation on the
Management interface.
show Enter the keyword show to display the settings on the Management interface.