Deployment Guide

BOOT_USER Mode | 73
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
In the runtime CLI of the C-Series and E-Series (not on S-Series), use the ip address command in the
INTERFACE mode to change the Management interface’s IP address.
If there is a mac address programmed in the eeprom, the show interface management ethernet
command gets the mac address from there and displays it. If there is no mac address programmed, the
following is used by default - 00:10:18:00:00:01.
To view the current IP address configured on the Management interface, enter the show interfaces
management ethernet command.
Related
Commands
interface management ethernet mac-address
s
Assign a MAC address to the Management Ethernet interface.
Syntax
interface management ethernet mac-address mac-address
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
Use this command to assign a MAC address if Dell Networking OS cannot find a default MAC
address.
Related
Commands
ip-address mask
Enter the IP address in dotted decimal format (A.B.C.D) and the mask in /
prefix-length format (/x).
Version 7.8.1.0 Introduced on S-Series
ip address Assign a primary and secondary IP address to the interface.
show default-gateway
Display the IP address configured for the default gateway.
show interface
management ethernet
Display the IP address configured for the Management interface.
mac-address
Enter a MAC address in standard format (xx:xx:xx:xx:xx:xx).
Version 7.8.1.0 Introduced on S-Series
show default-gateway
Display the IP address configured for the default gateway.
show interface management
ethernet
Display the IP address configured for the Management interface.