Deployment Guide

72 | BOOT_USER Mode
www.dell.com | support.dell.com
ignore startup-config
s
During a reload, do not load the startup-config file.
Syntax
ignore startup-config
Defaults
disabled
Command Modes
BOOT_USER
Command
History
Usage
Information
This command might be used if a the user has authentication procedures in the startup-config other
than the enable-password setting.
interface management
c
Associates a management port with a management VRF.
Syntax
interface management
To delete the association between a management port and a management VRF, use no interface
management command.
Defaults
None.
Command Modes
VRF MODE
Command
History
Usage
Information
Use this command to associate a management port with a management VRF. When you execute this
command, the management ports corresponding to both the ACTIVE unit as well as the STANDBY
unit are associated with the management VRF.
Related
Commands
interface management ethernet ip address
c e s
Assign an IP address to the Management Ethernet interface.
Syntax
[no] interface management ethernet ip address ip-address mask
To delete the IP address on the C-Series and E-Series (not on S-Series), enter no interface
management ethernet ip address.
Version 7.8.1.0 Introduced on S-Series
Version 8.4.7.0 Introduced on the C-Series.
ip address Assign a primary and secondary IP address to the interface.
show default-gateway
Display the IP address configured for the default gateway.
show interface
management ethernet
Display the IP address configured for the Management interface.