Deployment Guide

692 | IPv4 Routing
www.dell.com | support.dell.com
show ip management-route
c e
View the IP addresses assigned to the Management interface.
Syntax
show ip management-route [all | connected | summary | static]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 24-18. show ip management route Command Example
show ipv6 management-route
c e
Display the IPv6 static routes configured for the management interface.
Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
Status
States whether the interface is enabled (
up) or disabled (administratively
down
).
Protocol
States whether IP is enabled (up) or disabled (down) on the interface.
Table 24-13. show ip interface brief Column Headings (continued)
Field Description
all (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all
Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only routes directly
connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table listing the number
of active and non-active routes and their sources.
static (OPTIONAL) Enter the keyword static to view non-active routes also.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
FTOS#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
FTOS#
all Enter the keyword all to view all IP addresses assigned to all Management
interfaces on the switch.
connected Enter the keyword connected to view only routes directly connected to the
Management interface.