Deployment Guide

IPv4 Routing | 677
Related
Commands
management route
c e
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address | ipv6-address}/mask {forwarding-router-address |
managementethernet}
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables
are maintained for IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
ip-selection packet-based
Packet based: IPV4
No distribution: IPV6
Packet based: IPV4 MAC based
ip-selection packet-based and mac MAC based Packet based: IPV4 MAC based
Table 24-3. Configurations of the load-balance Command
Configuration Switched IP Traffic
Routed IP Traffic
(IPV4 Only)
Switched Non-IP
Traffic
ip address Change the algorithm used to distribute traffic on an E-Series chassis.
{ipv4-address | ipv6-address}/
mask
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X),
followed by the prefix-length for the IP address of the management
interface.
forwarding-router-address
Enter an IPv4 or IPv6 address of a forwarding router.
managementethernet Enter the keyword managementethernet for the
Management interface on the Primary RPM.
Version 8.4.1.0 Added support for IPv6 management routes.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
interface ManagementEthernet Configure the Management port on the system (either the Primary or
Standby RPM).
duplex (Management) Set the mode of the Management interface.
speed (Management interface) Set the speed for the Management interface.