Deployment Guide

IPv4 Routing | 671
ip proxy-arp
c e s
Enable Proxy ARP on an interface.
Syntax
ip proxy-arp
To disable Proxy ARP, enter no ip proxy-arp.
Defaults
Enabled.
Command Modes
INTERFACE
Command
History
Related
Commands
ip redirects
e
Enable the interface to send ICMP redirect messages.
Syntax
ip redirects
To return to default, enter no ip redirects.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Usage
Information
This command is available for physical interfaces and port-channel interfaces on the E-Series.
ip route
c e s
Assign a static route to the switch.
Syntax
ip route vrf {vrf instance} destination mask {ip-address | interface [ip-address]} [distance]
[permanent] [tag tag-value]
To delete a specific static route, use the no ip route destination mask {address | interface
[ip-address]} command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
show ip interface Displays the interface routing status and configuration.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
pre-Version 6.1.1.0 Introduced for E-Series
Note: This command is not supported on default VLAN (default vlan-id command).