Deployment Guide

Interfaces | 647
debug ip udp-helper
e
Enable UDP debug and display the debug information on a console.
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults
Debug disabled
Command Modes
EXEC
EXEC Privilege
Example
Figure 23-49. Debug Output Example
Related
Commands
ip udp-broadcast-address
e
Configure an IP UDP address for broadcast.
Syntax
ip udp-broadcast-address address
To delete the configuration, use the no ip udp-broadcast-address address command.
Parameters
Defaults
Not Configured
Command Modes
INTERFACE (config-if)
Usage
Information
When a UDP broadcast packet is flooded out of an interface, and the outgoing interface is configured
using this command, the outgoing packet’s IP destination address is replaced with the configured
broadcast address.
Related
Commands
FTOS#debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Gi 5/0 with IP DA (0xffffffff) will be sent on Gi 5/1 Gi 5/2
Vlan 3
01:44:54: Pkt rcvd on Gi 7/0 is handed over for DHCP processing.
ip udp-broadcast-address Configure a UDP IP address for broadcast
ip udp-helper udp-port Enable the UDP broadcast feature on an interface.
show ip udp-helper Display the configured UDP helper(s) on all interfaces.
address
Enter an IP broadcast address in dotted decimal format (A.B.C.D).
debug ip udp-helper Enable debug and display the debug information on a console.
show ip udp-helper Display the configured UDP helper(s) on all interfaces.