Deployment Guide

Internet Group Management Protocol (IGMP) | 575
ip igmp snooping mrouter
c e s
Statically configure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping mrouter interface
interface command.
Parameters
Defaults
Not configured
Command Modes
INTERFACE VLAN—(conf-if-vl-n)
Command
History
Usage
Information
Dell Networking OS provides the capability of statically configuring interface to which a multicast
router is attached. To configure a static connection to the multicast router, enter the ip igmp
snooping mrouter interface command in the VLAN context. The interface to the router must be a
part of the VLAN where you are entering the command.
ip igmp snooping querier
c e s
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, enter no ip igmp snooping querier
command.
Defaults
Not configured
Command Modes
INTERFACE VLAN—(conf-if-vl-n)
interface
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command