Deployment Guide

Border Gateway Protocol IPv4 (BGPv4) | 345
Related
Commands
Command
History
capture bgp-pdu neighbor
c e s
Enable capture of an IPv4 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx | tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv4-address command.
Parameters
Defaults
Not configured.
Command Modes
EXEC Privilege
Related
Commands
Command
History
capture bgp-pdu max-buffer-size
c e s
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
Defaults
40960000 bytes.
clear ip bgp ipv4 unicast soft
in
Activate inbound policies for IPv4 routes without resetting the BGP TCP
session.
Version 8.4.1.0 Added support for IPv4 multicast and IPv6 unicast address families
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced
Note: Starting in the C-Series release 8.4.7.0, this command is no longer supported.
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both | rx | tx}
Enter the keyword direction and a direction— either rx for
inbound,
tx for outbound, or both.
capture bgp-pdu max-buffer-size Specify a size for the capture buffer.
show capture bgp-pdu neighbor Display BGP packet capture information
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.5.1.0 Introduced
Note: Starting in the C-Series release 8.4.7.0, this command is no longer supported.
100-102400000
Enter a size for the capture buffer.