Deployment Guide

328 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
• show ip bgp filter-list
• show ip bgp flap-statistics
• show ip bgp inconsistent-as
• show ip bgp neighbors
• show ip bgp next-hop
• show ip bgp paths
• show ip bgp paths as-path
• show ip bgp paths community
• show ip bgp peer-group
• show ip bgp regexp
• show ip bgp summary
• show running-config bgp
• timers bgp
bgp add-path
c
Allow the advertisement of multiple paths for the same address prefix without the new paths replacing
any previous ones.
Syntax
bgp add-path [send | receive | both} path-count
Parameters
Defaults
Disabled.
Command Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command
History
Related
Commands
address-family
c e s
Enable the IPv4 multicast or the IPv6 address family.
Syntax
address-family [ipv4 {multicast | vrf vrf-name}!} ipv6unicast]
Parameters
send
Enter the keyword send to indicate that the system sends multiple paths to peers.
receive Enter the keyword receive to indicate that the system accepts multiple paths from
peers.
both Enter the keyword both to indicate that the system sends and accepts multiple
paths from peers.
path-count
Enter the number of paths supported. The range is from 2 to 64.
Version 8.4.7.0 Introduced support for VRF on C-Series.
bgp cluster-id specifies that this neighbor/peer group can send/receive multiple path
advertisements.
ipv4 multicast
Enter BGPv4 multicast mode.