Deployment Guide

Access Control Lists (ACL) | 263
Example
Figure 9-7. Command Example: mac-access-list standard
permit
c e s
Configure a filter to forward packets from a specific source MAC address.
Syntax
permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log]
[monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command syntax if you know the filter’s sequence number or
• Use the no permit {any | mac-source-address mac-source-address-mask} command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
FTOS(conf)#mac-access-list access-list standard TestMAC
FTOS(config-std-macl)#?
deny Specify packets to reject
description List description
exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Specify access-list entry remark
seq Sequence numbers
show Show Standard ACL configuration
any Enter the keyword any to forward all packets received with a MAC
address.
mac-source-address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If
no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other
words, the filter allows only MAC addresses that match).
count (OPTIONAL) Enter the keyword count to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to log the
packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL in which
you are creating the rule will be applied to the monitored interface.
For details, see the section “Flow-based Monitoring” in the Port
Monitoring chapter of the Dell Networking OS Configuration Guide.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series