Deployment Guide

262 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Command
History
Usage
Information
When you use the log option, CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
Related
Commands
mac access-list standard
c e s
Name a new or existing MAC access control list (MAC ACL) and enter the MAC ACCESS LIST
mode to configure a standard MAC ACL. See Commands Common to all ACL Types and Common
MAC Access List Commands.
Syntax
mac access-list standard mac-list-name
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS supports one ingress and one egress MAC ACL per interface.
Prior to 7.8.1.0, names are up to 16 characters long.
The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation
for detailed specification on entries allowed per ACL.
C-Series and S-Series support ingress ACLs only.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 7.4.1.0
Added
monitor option
pre-Version 6.1.1.0 Introduced for E-Series
Note: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
permit Configure a MAC address filter to pass packets.
seq Configure a MAC address filter with a specified sequence number.
mac-list-name
Enter a text string as the name of the standard MAC access list (140 character
maximum).
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series