Deployment Guide

26 | CLI Basics
www.dell.com | support.dell.com
To enter REDIRECT-LIST mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Use the ip redirect-list command. You must include a name for the Redirect-list.The prompt
changes to include (conf-redirect-list).
You can return to the CONFIGURATION mode by entering the exit command.
SPANNING TREE Mode
Use the STP mode to enable and configure the Spanning Tree protocol, as described in Chapter 58,
Spanning Tree Protocol (STP).
To enter STP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the protocol spanning-tree stp-id command.
You can return to the CONFIGURATION mode by entering the exit command.
Per-VLAN SPANNING TREE Plus Mode
Use PVST+ mode to enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, as
described in Chapter 46, Per-VLAN Spanning Tree plus (PVST+).
To enter PVST+ mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the protocol spanning-tree pvst command.
You can return to the CONFIGURATION mode by entering the exit command.
RAPID SPANNING TREE Mode
Use PVST+ mode to enable and configure the RSTP protocol, as described in Chapter 50, Rapid
Spanning Tree Protocol (RSTP).
To enter RSTP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the protocol spanning-tree rstp command.
You can return to the CONFIGURATION mode by entering the exit command.
MULTIPLE SPANNING TREE Mode
Use MULTIPLE SPANNING TREE mode to enable and configure the Multiple Spanning Tree
protocol, as described in Chapter 34, Multiple Spanning Tree Protocol (MSTP).
Note: The protocol is PVST+, but the plus sign is dropped at the CLI prompt