Deployment Guide

CLI Basics | 25
To enter ROUTE-MAP mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Use the route-map map-name [permit | deny] [sequence-number] command. The prompt
changes to include (route-map).
You can return to the CONFIGURATION mode by entering the exit command.
PREFIX-LIST Mode
While in the CONFIGURATION mode, use the ip prefix-list command to enter the PREFIX-LIST
mode and configure a prefix list.
To enter PREFIX-LIST mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Enter the ip prefix-list command. You must include a name for the prefix list.The prompt
changes to include (conf-nprefixl).
You can return to the CONFIGURATION mode by entering the exit command.
AS-PATH ACL Mode
Use the AS-PATH ACL mode to configure an AS-PATH Access Control List (ACL) on the E-Series.
See Chapter 9, Access Control Lists (ACL).
To enter AS-PATH ACL mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Enter the ip as-path access-list command. You must include a name for the AS-PATH
ACL.The prompt changes to include (config-as-path).
You can return to the CONFIGURATION mode by entering the exit command.
IP COMMUNITY LIST Mode
Use the IP COMMUNITY LIST mode to configure an IP Community ACL on the E-Series. See
Chapter 9, Access Control Lists (ACL).
To enter IP COMMUNITY LIST mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Enter the ip community-list command. You must include a name for the Community list.The
prompt changes to include (config-community-list).
You can return to the CONFIGURATION mode by entering the exit command.
REDIRECT-LIST Mode
Use the REDIRECT-LIST mode to configure a Redirect list on the E-Series, as described in
Chapter 39, Policy-based Routing (PBR).