Deployment Guide

22 | CLI Basics
www.dell.com | support.dell.com
Usage
Information
You can activate VRF application on a device by using the feature vrf command in
CONFIGURATION mode. The no feature vrf command is not supported on the C-Series platform.
show feature
c
Verify the status of software applications, such as VRF, that are activated and running on a device.
Syntax
show feature
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
You can activate VRF application on a device by using the feature vrf command in
CONFIGURATION mode. The
no feature vrf command is not supported on the C0-Series platform.
Example
Figure 2-5. show feature Command Examples
Command Modes
To navigate to various CLI modes, you need to use specific commands to launch each mode.
Navigation to these modes is discussed in the following sections.
EXEC Mode
When you initially log in to the switch, by default, you are logged into the EXEC mode. This mode
allows you to view settings and to enter the EXEC Privilege mode to configure the device. While you
are in the EXEC mode, the > prompt is displayed following the “hostname” prompt, as described
above. which is “FTOS” by default. You can change it with the hostname command. See the
command hostname. Each mode prompt is preceded by the hostname.
EXEC Privilege Mode
The enable command accesses the EXEC Privilege mode. If an administrator has configured an
“Enable” password, you will be prompted to enter it here.
Version 8.4.7.0 Introduced in the C-Series.
Dell#show feature
Feature State
--------- -------
VRF enabled
Note: Some of the following modes are not available on C-Series or S-Series.