Deployment Guide

166 | Control and Monitoring
www.dell.com | support.dell.com
Command
History
Usage
Information
Telnet to link-local addresses is not supported.
Example
telnet-peer-rpm
c e
Open a Telnet connection to the peer RPM.
Syntax
telnet-peer-rpm
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
Opening a telnet connection from the Standby RPM to an Active RPM follows the authentication
procedure configured in the chassis. However, opening a telnet connection from the Active RPM into
the Standby RPM requires local authentication.
Configuring an ACL on a VTY line will block a Telnet session using the telnet-peer-rpm command
in the standby to active RPM direction only. Such an ACL will not block an internal Telnet session in
the active RPM to standby RPM direction.
Version 8.4.7.0 Introduced VRF on the C-Series.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 8.2.1.0 Introduced on E-Series ExaScale (IPv6)
Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4)
Version 7.9.1.0 Introduced VRF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and added support for IPv6 address on E-Series only
Dell(conf)#do telnet vrf vrf1 10.10.10.2
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series