Deployment Guide

164 | Control and Monitoring
www.dell.com | support.dell.com
• show ip protocols
• show ip route summary
• show processes cpu
• show processes memory
• show redundancy
• show running-conf
• show version
Related
Commands
ssh-peer-rpm
c e
Open an SSH connection to the peer RPM.
Syntax
ssh-peer-rpm [-l username]
Parameters
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
This command is not available when the peer RPMs are running different Dell Networking OS
releases.
telnet
c e s
Connect through Telnet to a server. The Telnet client and server in Dell Networking OS support IPv4
and IPv6 connections. You can establish a Telnet session directly to the router, or a connection can be
initiated from the router.
show version Display the Dell Networking OS version.
show system (S-Series) Display the current switch status.
show environment (S-Series)
Display
system component status.
show processes memory (S-Series) Display memory usage based on running processes.
-l username (OPTIONAL) Enter the keyword -l followed by your user name.
Default: The user name associated with the terminal
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
Version 6.3.1.0 Introduced on E-Series
Note: The Telnet server and client are VRF-aware. Using the vrf parameter in this command,
you can make a Telnet server or client to listen to a specific VRF. This capability enables a
Telent server or client to look up the correct routing table and establish a connection.