Deployment Guide

4 |
www.dell.com | support.dell.com
lacp ungroup member-independent
c
Prevent possible loop during the boot up of a VLT peer switch or a device that accesses the VLT
domain.
Syntax
lacp ungroup member-independent {vlt | port-channel}
Parameters
Defaults
Not Configured.
Command Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Usage
Information
LACP on the VLT ports (on a VLT switch or access device), which are members of the virtual link
trunk, is not brought up until the VLT domain is recognized on the access device.
To ungroup the VLT and port-channel configurations, use the no lacp ungroup member independent
command on a VLT port channel, depending on whether the port channel is VLT or non-VLT.
Example
multicast peer-routing timeout
c
Configure the time for a VLT node to retain synced multicast routes or synced multicast outgoing
interface (OIF) after a VLT peer node failure.
Syntax
multicast peer-routing timeout value
To restore the default value, use the no multicast peer-routing timeout command.
Parameters
Command Modes
VLT DOMAIN (conf-vlt-domain)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
port-channel
Force all LACP port-channel members to become switchport.
vlt
Force all VLT LACP members to become switch-ports.
Version 8.4.6.0 Introduced on the C-Series.
Dell Networking OS (conf)#lacp ungroup member-independent ?
port-channel LACP port-channel members become switchports
vlt All VLT LACP members become switchports
value
Enter the timeout value in seconds. The range is from 1 to 1200. The
default is 150.