Deployment Guide

1508 | Virtual Routing and Forwarding (VRF)
www.dell.com | support.dell.com
Example
Usage
Information
The total block number of VLANs applies to every configured VRF process. You cannot set different
blocks for different VRF processes.
All VLAN member ports must be removed from the VLAN before the VLAN is deleted from a VRF
instance.
Related
Commands
interface management
c
Associates a management port with a management VRF.
Syntax
interface management
To delete the association between a management port and a management VRF, use the no interface
management
command.
Command Modes
VRF MODE
Defaults
None
Command
History
Usage
Information
Use this command to associate a management port with a management VRF. When you execute this
command, the management ports corresponding to both the ACTIVE unit as well as the STANDBY
unit are associated with the management VRF.
show ip vrf
ce
Display the interfaces assigned to VRF instances.
Syntax
show ip vrf [vrf-name]
Parameters
Command Modes
EXEC
Command
History
FTOS#conf
FTOS(conf)#ip vrf-vlan-block 1024
FTOS(conf)#
Enter the number as a power of 2.
start-vlan-id
Set the starting VLAN ID for a VRF instance.
Version 8.4.7.0 Introduced on the C-Series
vrf-name
Enter the name of a non-default VRF instance. To display information on all VRF
instances (including the default VRF 0), do not enter a value.
Version 8.2.1.0 Introduced on the E-Series