Deployment Guide

1402 | SNMP and Syslog
www.dell.com | support.dell.com
Parameter
Defaults
The IP address assigned to the management interface is the default.
Command Modes
CONFIGURATION
Command
History
Usage
Information
For this snmp-server trap-source command to be enabled, you must configure an IP address on the
interface and enable the interface configured as an SNMP trap source.
Related
Commands
snmp-server user
c e s
Configure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port
port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv des56 priv
password] [access-list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name
remote ip-address vrf vrf-name udp-port port-number} [1 | 2c | 3 ] [encrypted] [auth {md5 |
sha} auth-password] [priv des56 priv password] [access-list-name | ipv6 access-list-name |
access-list-name ipv6 access-list-name] command.
Parameters
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed
by the slot/port information.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
snmp-server community Set the community string.
name
Enter the name of the user (not to exceed 20 characters), on the host, that
connects to the agent.
group_name
Enter a text string (up to 20 characters long) as the name of the group.
Defaults: The following groups are created for mapping to read/write
community/security-names.
• v1v2creadu — maps to a community with
ro permissions
•
1v2cwriteu — maps to a community rw permissions