Deployment Guide

Quality of Service (QoS) | 1223
Command
History
Usage
Information
You must enter the class-map command in order to access this command. Once the class map is
identified, you can configure the match criteria.
The match ip precedence command and the match ip dscp command are mutually exclusive.
Up to eight precedence values can be matched in one match statement. For example, to indicate the IP
precedence values 0 1 2 3 enter either the command match ip precedence 0-3 or match ip
precedence 0,1,2,3.
Related
Commands
match ip vlan
c e s
Uses a VLAN as the match criterion for an L3 class map.
Syntax
match ip vlan vlan-id
To remove VLAN as the match criterion, use the no match ip vlan vlan-id command.
Parameters
Defaults
None
Command Modes
CONF-CLASS-MAP
Command
History
Usage
Information
To access this command, enter the class-map command. After the class map is identified, you can
configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID.
Related
Commands
Version 7.7.1.0
Added keyword
multicast.
Added DSCP marking option support for S-Series
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Added support for DSCP Marking option
Version 6.2.1.1 Introduced on E-Series
Note: Only one of the IP precedence values must be a successful match criterion, not all of
the specified IP precedence values need to match.
class-map Identify the class map.
vlan vlan-id
Enter the keyword vlan and then the ID of the VLAN. The range is from 1 to
4094.
Version 8.4.7.0 Introduced on the C-Series.
class-map Identify the class map.