Deployment Guide

Control and Monitoring | 117
show cpu-traffic-stats
c e s
View the CPU traffic statistics.
Syntax
show cpu-traffic-stats [port number | all | cp | linecard {all | slot# } | rp1 | rp2 ]
Parameters
Defaults
all
Command Modes
EXEC
Command
History
E-Series Example
Figure 5-14. Command Example: show cpu-traffic-stats on the E-Series
port number
(OPTIONAL) Enter the port number to display traffic statistics on that port only.
Range: 1 to 1568
all (OPTIONAL) Enter the keyword all to display traffic statistics on all the interfaces
receiving traffic, sorted based on traffic.
cp (OPTIONAL) Enter the keyword cp to display traffic statistics on the specified
CPU.
Note: This option is supported on E-Series only.
linecard (OPTIONAL) Enter the keyword linecard followed by either all or the slot
number to display traffic statistics on the designated line card.
Note: This option is supported on C-Series only.
rp1
(OPTIONAL) Enter the keyword rp1 to display traffic statistics on the RP1.
Note: This option is supported on E-Series only.
rp2 (OPTIONAL) Enter the keyword rp2 to display traffic statistics on the RP2.
Note: This option is supported on E-Series only.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
FTOS#show cpu-traffic-stats
Processor : CP
--------------
Received 100% traffic on GigabitEthernet 8/2 Total packets:100
LLC:0, SNAP:0, IP:100, ARP:0, other:0
Unicast:100, Multicast:0, Broadcast:0
Processor : RP1
---------------
Received 62% traffic on GigabitEthernet 8/2 Total packets:500
LLC:0, SNAP:0, IP:500, ARP:0, other:0
Unicast:500, Multicast:0, Broadcast:0
Received 37% traffic on GigabitEthernet 8/1 Total packets:300
LLC:0, SNAP:0, IP:300, ARP:0, other:0
Unicast:300, Multicast:0, Broadcast:0
Processor : RP2
---------------
No CPU traffic statistics.
FTOS#