Deployment Guide

Open Shortest Path First (OSPFv2 and OSPFv3) | 1055
• If passive-interface default is specified, then save no passive-interface interface into the
running configuration.
No passive-interface default
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
On configuring suppression using the passive-interface command, the state of the OSPF neighbor does
not change to INIT; instead, the state of the OSPF neighbor changes to DOWN after the dead-timer
expires.
redistribute
c e s
Redistribute information from another routing protocol throughout the OSPF process.
Syntax
redistribute {connected | rip | static} [metric metric-value | metric-type type-value]
[route-map map-name] [tag tag-value]
To disable redistribution, use the no redistribute {connected | isis | rip | static} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER OSPF
Command
History
Usage
Information
To redistribute the default route (0.0.0.0/0), configure the default-information originate command.
connected Enter the keyword connected to specify that information from active routes
on interfaces is redistributed.
rip Enter the keyword rip to specify that RIP routing information is redistributed.
static Enter the keyword static to specify that information from static routes is
redistributed.
metric metric-value (OPTIONAL) Enter the keyword metric followed by a number.
Range: 0 (zero) to 16777214.
metric-type
type-value
(OPTIONAL) Enter the keyword metric-type followed by one of the
following:
• 1 = OSPF External type 1
• 2 = OSPF External type 2
route-map map-name (OPTIONAL) Enter the keyword route-map followed by the name of the
route map.
tag tag-value (OPTIONAL) Enter the keyword tag followed by a number.
Range: 0 to 4294967295
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series