Deployment Guide

100 | Control and Monitoring
www.dell.com | support.dell.com
ip tftp source-interface
c e s
Assign an interface’s IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
ip ftp vrf
c
Configures an FTP client with a VRF that is used to connect to the FTP server.
Syntax
ip ftp vrf {management | WORD}
To undo the FTP client configuration, use the no ip ftp vrf { management | WORD} command.
Parameters
Command Modes
CONFIGURATION
Defaults
Disabled
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from zero
(0) to 16383.
• For a Port Channel, enter the keyword
port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale
• For the SONET interfaces, enter the keyword
sonet followed by slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
vrf
Enter the keyword vrf.
management
Enter the keyword management to configure FTP client with a management VRF.
WORD
Enter the name of the non-default VRF with which you want to configure the FTP client.