Command Line Reference Guide

904 | Layer 2
www.dell.com | support.dell.com
If the track ip command is not configured, the VLAN's Layer 3 operational state depends on all the
members of the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 traffic is not affected by the track ip command
configuration.
Related
Commands
untagged
c e s
Add a Layer 2 interface to a VLAN as an untagged interface.
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface command.
Parameters
Defaults
All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
Untagged interfaces can only belong to one VLAN.
In the Default VLAN, you cannot use the no untagged interface command. To remove an untagged
interface from all VLANs, including the Default VLAN, enter the INTERFACE mode and use the no
switchport command.
Related
Commands
interface vlan Configure a VLAN.
tagged Specify which interfaces in a VLAN are tagged.
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
Version 8.4.6.0
Added support for the keyword
fortyGigE.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
interface vlan Configure a VLAN.
tagged Specify which interfaces in a VLAN are tagged.