Command Line Reference Guide

772 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
Other BGP filtering commands include: neighbor filter-list and neighbor route-map.
Related
Commands
neighbor ebgp-multihop
c e
Attempt and accept BGP connections to external peers on networks that are not directly connected.
Syntax
neighbor {ipv6-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ipv6-address | peer-group-name}
ebgp-multihop [ttl] command.
Parameters
Defaults
Disabled.
Command Modes
ROUTER BGP
Command
History
Usage
Information
To prevent loops, the neighbor ebgp-multihop command will not install default routes of the multihop
peer. Networks not directly connected are not considered valid for best path selection.
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
neighbor filter-list Assign a AS-PATH list to a neighbor or peer group.
neighbor route-map Assign a route map to a neighbor or peer group.
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group.
ttl
(OPTIONAL) Enter the number of hops as the Time to Live (ttl) value.
Range: 1 to 255.
Default: 255
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale