Command Line Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 759
Parameters
Command Modes
EXEC Privilege
Command
History
clear ip bgp peer-group
c e
Reset a peer-group’s BGP sessions.
Syntax
clear ip bgp peer-group peer-group-name
Parameters
Command Modes
EXEC Privilege
Command
History
clear ip bgp ipv6 dampening
c e
Clear information on route dampening and return suppressed route to active state.
Syntax
clear ip bgp ipv6 unicast dampening [ipv6-address]
ipv6-address
Enter an IPv6 address to reset neighbors belonging to that IP. Used without a
qualifier, the keyword resets all neighbors belonging to that IP.
flap-statistics (OPTIONAL) Enter the keyword flap-statistics to clear all flap
statistics belonging to that AS or a specified address family within that IP.
ipv4 (OPTIONAL) Enter the keyword ipv4 to select options for that address
family.
ipv6 (OPTIONAL) Enter the keyword ipv6 to select options for that address
family.
unicast (OPTIONAL) Enter the keyword unicast to select the unicast option
within the selected address family.
multicast (OPTIONAL) Enter the keyword multicast to select the multicast option
within the selected address family.
Multicast is supported on IPv4 only
soft (OPTIONAL) Enter the keyword soft to configure and activate policies
without resetting the BGP TCP session, that is, BGP Soft Reconfiguration.
Note: If you enter clear ip bgp ip6-address soft, both inbound and
outbound policies are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound policies.
out (OPTIONAL) Enter the keyword out to activate only outbound policies.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
peer-group-name
Enter the peer group name to reset the BGP sessions within that peer group.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale