Command Line Reference Guide

632 | Interfaces
www.dell.com | support.dell.com
• An IP payload is going out of a Layer 2 LAG interface that is a member of a VLAN with an IP
address.
FTOS#show port-channel-flow outgoing-port-channel 2 incoming-interface gi 3/
0 source-ip 2.2.2.0 destination-ip 3.2.3.1 protocol tcp source-port 5
destination-port 6
Egress Port for port-channel 2, for the given flow:
Unfragmented packet: Gi 1/6
Fragmented packets (first fragment): Gi 1/12
Fragmented packets (remaining fragments): Gi 1/12
Related
Commands
Time Domain Reflectometer (TDR)
TDR is supported on E-Series ExaScale e
x
with Dell Networking OS 8.2.1.0. and later.
TDR is useful for troubleshooting an interface that is not establishing a link; either it is flapping or not
coming up at all. TDR detects open or short conditions of copper cables on 100/1000 Base-T modules.
• tdr-cable-test
• show tdr
Important Points to Remember
• The interface and port must be enabled (configured—see the interface command) before running
TDR. An error message is generated if you have not enabled the interface.
• The interface on the far-end device must be shut down before running TDR.
• Since TDR is an intrusive test on an interface that is not establishing a link, do not run TDR on an
interface that is passing traffic.
• When testing between two devices, do not run the test on both ends of the cable.
tdr-cable-test
c e s
Test the condition of copper cables on 100/1000 Base-T modules.
Syntax
tdr-cable-test interface
Parameters
Defaults
No default behavior or setting
Command Modes
EXEC
Command
History
load-balance (E-Series) Balance traffic over E-Series port channel members.
interface Enter the keyword GigabitEthernet followed by the slot/port
information for the 100/1000 Ethernet interface.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series