Command Line Reference Guide

Interfaces | 627
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Usage
Information
This feature groups two LAGs to work in tandem as a supergroup, so that, for example, if one LAG
goes down, the other LAG is taken down automatically, providing an alternate path to reroute traffic,
avoiding oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to
configure failover groups. For details, see the Port Channel chapter in the Dell Networking OS
Configuration Guide.
Related
Commands
show config
c e s
Display the current configuration of the selected LAG.
Syntax
show config
Command Modes
INTERFACE PORTCHANNEL
Example
Figure 23-44. show config Command Sample Output for a Selected LAG
Command
History
show interfaces port-channel
c e s
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief]
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced for C-Series, E-Series, and S-Series
group Group two LAGs in a supergroup (“fate-sharing group”).
show interfaces port-channel Display information on configured Port Channel groups.
FTOS(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
FTOS(conf-if-po-1)#
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series