Command Line Reference Guide

626 | Interfaces
www.dell.com | support.dell.com
If the line card is in a Jumbo mode chassis, then the mtu and ip mtu commands can also be configured.
The Link MTU and IP MTU values configured on the channel members must be greater than the Link
MTU and IP MTU values configured on the Port Channel interface.
Related
Commands
minimum-links
c e s
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for
the LAG to be also in “oper up” status.
Syntax
minimum-links number
Parameters
Defaults
1
Command Modes
INTERFACE
Command
History
Usage
Information
If you use this command to configure the minimum number of links in a LAG that must be in “oper up”
status, then the LAG must have at least that number of “oper up” links before it can be declared as up.
For example, if the required minimum is four, and only three are up, then the LAG will be considered
down.
port-channel failover-group
c e s
Access the PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover group.
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group command.
Note: In a Jumbo-enabled system, all members of a Port Channel must be configured with the
same link MTU values and the same IP MTU values.
channel-member Add a physical interface to the LAG.
interface Configure a physical interface.
interface loopback Configure a Loopback interface.
interface null Configure a null interface.
interface vlan Configure a VLAN.
shutdown Disable/Enable the port channel.
number
Enter the number of links in a LAG that must be in “oper up” status.
Range: 1 to 16
Default: 1
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series