Command Line Reference Guide

60 | File Management
www.dell.com | support.dell.com
Example
Command example: upgrade fpga-image
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
Related
Commands
upgrade poe-controller-firmware
c
Upgrade the PoE controller on the line cards.
Syntax
upgrade poe-controller-firmware linecard {number | all} booted
Parameters
Defaults
None
Command Mode
EXEC Privilege
Command
History
FTOS# upgrade fpga-image linecard 6 booted
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
------------------------------------------------------------------------
LC6 48 Port 1G LCM POEPLUS FPGA A: 0.1 0.1
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Please do not reset/powercyle or reload. *
* Proceed with caution ! *
***********************************************************************
Upgrade fpga image for linecard 6 [yes/no]: y
FPGA upgrade in progress. Please do NOT power off the card.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Linecard 6 FPGA upgrade successful.
FTOS#
reset
Reset a line card or RPM.
restore fpga-image
This command copies the backup FPGA image to the primary FPGA image.
linecard number Enter the keyword linecard followed by the line card slot number to
upgrade the PoE controller.
Range: 0-7 on the C7008/C300, 0-3 on the C7004/C150
all Enter the keyword all after the keyword linecard to upgrade all PoE
controllers on all line cards.
booted
Upgrade the PoE controller using the currently running Dell Networking
OS image.
Version 8.4.5.0 Introduced on C-Series