Command Line Reference Guide

580 | Interfaces
www.dell.com | support.dell.com
• When the interface range prompt has multiple port ranges, the smaller port range is excluded from
the prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest start port and the
biggest end port.
Example
Figure 23-9. Bulk Configuration Warning Message
Example
Figure 23-10. Interface Range prompt with Multiple Ports
Example
Figure 23-11. Interface Range prompt Overlapping Port Ranges
Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel
commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or
port-channel interfaces that are not displayed in the show running-config command can not be used
with the bulk configuration feature of the interface range command. You cannot create virtual
interfaces (VLAN, Port-channel) using the interface range command.
The following figure is an example of a single range bulk configuration.
Example
Figure 23-12. Single Range Bulk Configuration
The following figure shows how to use commas to add different interface types to the range enabling
all Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and
1/2.
Example
Figure 23-13. Multiple Range Bulk Configuration Gigabit Ethernet and Ten Gigabit
Ethernet
FTOS(conf)#interface range so 2/0 - 1 , te 10/0 , gi 3/0 , fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
FTOS(conf)#interface range gi 2/0 - 23 , gi 2/1 - 10
FTOS(conf-if-range-gi-2/0-23#
Note: If a range has VLAN, physical, port-channel, and SONET interfaces, only commands
related to physical interfaces can be bulk configured. To configure commands specific to VLAN,
port-channel or SONET, only those respective interfaces should be configured in a particular
range.
FTOS(conf)#interface range gi 2/1 - 11 , gi 2/1 - 23
FTOS(conf-if-range-gi-2/1-23#
FTOS(config)# interface range gigabitethernet 5/1 - 23
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#
FTOS(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#