Command Line Reference Guide

578 | Interfaces
www.dell.com | support.dell.com
Example
Figure 23-7. interface ManagementEthernet Command Example
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). Use the ip address command to assign an
IP address to the Management port.
If two RPMs are installed in your system, use the show redundancy command to display which RPM is
the Primary RPM.
Related
Commands
interface null
c e s
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
Defaults
Not configured; number = 0
Command Modes
CONFIGURATION
Command
History
Example
Figure 23-8. interface null Command Example
Usage
Information
You cannot delete the Null interface. The only configuration command possible in a Null interface is ip
unreachables.
Related
Commands
FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#
management route Configure a static route that points to the Management interface or a
forwarding router.
duplex (Management) Clear FIB entries on a specified line card.
speed (Management interface) Clear FIB entries on a specified line card.
number
Enter zero (0) as the Null interface number.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.4.1.0 Introduced
FTOS(conf)#interface null 0
FTOS(conf-if-nu-0)#
interface Configure a physical interface.
interface loopback Configure a Loopback interface.
interface port-channel Configure a port channel.
interface vlan Configure a VLAN.
ip unreachables Enable generation of ICMP unreachable messages.