Command Line Reference Guide

Interfaces | 575
• Dell Networking OS only supports rx on tx on and rx off tx off for speeds less than 1 Gig
(Symmetric).
• On the C-Series and S-Series systems, the flow-control sender and receiver must be on the same
port-pipe. Flow control is not supported across different port-pipes on the C-Series or S-Series
system.
Example
Figure 23-4. show running config (partial)
The table below displays how Dell Networking OS negotiates the flow control values between two
Dell Networking chassis connected back-to-back using 1G copper ports.
Related
Commands
FTOS(conf-if-gi-0/1)#show config
!
interface GigabitEthernet 0/1
no ip address
switchport
no negotiation auto
flowcontrol rx off tx on
no shutdown
...
Table 23-1. Negotiated Flow Control Values
Configured Negotiated
LocRxConf LocTxConf RemoteRxConf RemoteTxConf LocNegRx LocNegTx RemNegRx RemNegTx
off off off
off
on
on
off
on
off
on
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off on off
off
on
on
off
on
off
on
off
off
off
off
off
off
on
off
off
off
on
off
off
off
off
off
on off off
off
on
on
off
on
off
on
off
on
on
on
off
off
on
on
off
off
on
on
off
on
on
on
on on off
off
on
on
off
on
off
on
off
off
on
on
off
off
on
on
off
off
on
on
off
off
on
on
show running-config Display the flow configuration parameters (non-default values only).
show interfaces Display the negotiated flow control parameters.