Command Line Reference Guide

506 | Dell Networking OS Service Agent
www.dell.com | support.dell.com
debug call-home
c e
Monitor FTSA email messages through the CLI.
Syntax
debug call-home
To turn message monitoring off, use the no debug call-home command.
Defaults
no debug call-home
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
default-action
c e
Select the information collection action that matches the equivalent test group.
Syntax
default-action {hardware | software | exception}
Parameters
Defaults
No default behavior or values
Command Mode
CALL-HOME ACTION-LIST
Command
History
Usage
Information
Starting with Dell Networking OS 7.8.1.0, after you use the policy-test-list and default-list
commands to put you in the config-callhome-actionlist mode, you can use the default-action
command to select any test group.
The FTSA message (or log entry) contains the information collected by the selected action.
Related
Commands
Version 7.6.1.0 Introduced on C-Series
Version 6.3.1.0 Introduced for E-Series
show debugging Display the status of FTSA (call-home) debugging.
hardware Enter the keyword hardware to collect hardware information. See the Dell Networking
OS Configuration Guide for the list of actions executed by this keyword.
software Enter the keyword software to collect software information. See the Dell Networking OS
Configuration Guide for the list of actions executed by this keyword.
exception Enter the keyword exception to collect exception information. See the Dell Networking
OS Configuration Guide for the list of actions executed by this keyword.
Version 7.7.1.0 Introduced on C-Series and E-Series
policy-action-list This command names the policy action list and enters the
config-callhome-actionlist-name mode.